We prepare designs with the knowledge of how installation actually happens on site. Systems are coordinated with each other in advance — cable routes, ducts and pipes do not collide above the ceiling, and the need for changes and additional costs during construction is reduced.
We deliver full design packages as well as single disciplines — for new construction, renovation and buildings already in use.
Which systems we design
- Electrical systems
- Heatingandcooling
- Ventilation systems
- Plumbing and drainage
- Fire protection systems
- Low-voltage systems
- Building management systems (BMS)
- Solarenergy
Engineering calculations
- Electrical load, load balancing and power distribution scheme
- Heating and cooling loads, room by room
- Air flow rates and air balance
- Water demand and hydraulic calculations
Survey and initial stage
- Site survey and collection of input data
- Preparation of the technical brief together with the client
Documentation
- Equipment selection and specification — with at least two alternatives
- Bill of quantities and cost estimate
- Preparation of documentation for approvals
Engineering calculations
- Electrical load, load balancing and power distribution scheme
- Heating and cooling loads, room by room
- Air flow rates and air balance
- Water demand and hydraulic calculations
Documentation
- Equipment selection and specification — with at least two alternatives
- Bill of quantities and cost estimate
- Preparation of documentation for approvals
Review of an existing design
If you already have a design, we will check it and provide a written report. Finding a flaw before installation is always cheaper than correcting it afterwards.
On handover you receive: complete design documentation, digital and printed · calculation summaries · equipment specifications · cost estimate
When you need it: New construction · Renovation · Capacity upgrade · Change of building use
